Veris Industries 1010 Manual - Manual (Page 6)

1) Starting with the 1010 turned off, press and hold down the
2) Using the Arrow keys, set the year. Once the year is set, press
3) Using the Arrow keys, set the month. Once the month is set, press
4) Using the Arrow keys, set the day. Once the day is set, press
5) Using the Arrow keys, set the hour. Once the hour is set press
6) Using the Arrow keys set the minutes. Once minutes is set, press
The 1010 will return to normal operation.
key then
press and hold down the key until two beeps are heard and the time / date
screen is displayed.
Year
Month / Day
Hour / Minutes
(24 hour clock, HH:MM)
4.6 Setting Date and Time
The 1010 is equipped with an audible and visual alarm for carbon monoxide. The
alarm level is factory set at 30ppm. When CO above this level is measured, the
1010 will beep and the display will flash red.
The alarm level is adjustable and can be set from 10ppm to 500ppm.
Using the Arrow keys set the alarm point to the desired level. The
keys select the digit and the keys increase or decrease the value.
Once the desired alarm point is set, press the key to return to normal
operation.
1) With the 1010 turned on, press and hold down the
CO alarm level in ppm
4.7 Setting CO Alarm Level
and keys
until the CO alarm screen is displayed.