Veris Technologies pH Manager - Operating Instructions - Manual (Page 6)

Pub.# OM17-MSP-pH
2-3
Figure 5 DataLogger (rear)
Figure 6 DataLogger (front)
Important
– Do not allow moisture to enter the Soil EC Surveyor or Sensor DataLogger, and
do not pass strong magnets near the unit.
Data Status:
When lit, this green
LED indicates data
is being recorded to
memory card. If not
lit, EC values are
negative or GPS
signal not received. Power:
When lit, this red
LED indicates
Sensor DataLogger
is powered up. Memory Card slot:
SD memory storage
card must be
installed when
booting up, and at all
times data is being
collected.
pH:
Serial cable from pH
Controller (MSP
only) attaches here.
Reset
button:
Can be used
to reboot
DataLogger
Power port:
The Sensor DataLogger is
shipped with an accessory
power cord. If an alternative
connection is desired, make
sure that the unit is properly
connected to a power
connection that is not
controlled by the ignition
switch. If connecting directly
to the battery, we suggest a
3-amp in-line fuse is
installed between the battery
and the instrument.
Alarm Vol:
Used to adjust
volume of auditory
alarm
EC:
Serial cable
from EC
Surveyor
attaches here.
On/Off:
Turns power to
Sensor DataLogger
on and off.
Fuse:
This allows the fuse
to be replaced, with
a 500mA Fastblow
fuse, if blown.