Veris Technologies pH Manager - Operating Instructions - Manual (Page 37)

Pub.# OM17-MSP-pH
4-8
Note: if MSP is equipped with EC Module and EC data is being collected along with pH data,
adjusting the overall height of the unit will affect coulter-electrode depth. If deeper soil sampling is
desired, and removing cylinder stops would result in excessive coulter-electrode depth, remove
sampler shank pins and lower shank to lowest setting. If shallower soil sampling is required, and
adding cylinder stops results in inadequate coulter-electrode depth for EC data collection, raise
sampler shank to highest setting.
Figure 13
Once EC coulter depth and sampling depth are satisfactory, adjust other components in this
sequence:
1. Scraper adjustment: in manual mode hydraulically raise the sampling shoe to maximum height.
Adjust scraper until cutting shoe clears scraper blade when sampler shank is fully raised.
Figure 14
pull adjustment pins and
lower shank if deeper
sampling is needed (and
EC coulter depth is
satisfactory)
Adjust scraper bracket
until cutting shoe
clears scraper when
sampler assembly is
raised completely.