Veris Technologies pH Manager - Operating Instructions User Manual
Page 20
Pub.# OM17-MSP-pH
3-12
Field Operations
—pH Electronics with SoilViewer
Attach the pH serial communication cable to an available COM port on your computer. Connect EC
signal cable, GPS, and power cords to ports on rear of EC Surveyor, then connect EC Data Out to
any available COM port on your computer using a standard serial cable. If serial port is not
available on PC, then a USB to Serial converter can be used with the EC Surveyor provided the
drivers for the converter are installed and functioning properly. NOTE: EC signal is required for
pH data to be recorded. If no EC data is desired or available, install EC test load on EC
Surveyor signal port.
Figure 1 DataLogger (rear)
SoilViewer startup display
Here are the display readings that you will see when operating the EC/pH SoilViewer Software:
Figure 2