Ohaus CARAT PLUS PRECISION JEWELRY BALANCES Manual en - Manual (Page 21)

Adventurer Pro EN-19
3.5.3 Percent Weighing (Cont.)
Place the sample on the pan and press the Function button.
This example illustrates 50 grams as the reference weight.
Remove the reference weight and place the item to be compared
on the pan. The balance indicates the actual percentage on
the primary display. The secondary display indicates the weight
in the selected measuring unit.
Pressing the Function button momentarily displays the reference
weight on the secondary display.
Clearing the Reference Weight
Press and hold the
Mode button until PERCENT is shown on
the secondary display.
3.5.4 Check Weighing
Check Weighing is used to compare the weight of a sample
against target limits.
Press and hold the Mode button. When Check Weighing is
displayed, release the button. If Check Weighing limits
previously have been set and stored in memory, the secondary
display shows Edit REF? (blinking). Press No to use the
stored limits and begin Check Weighing, or press
Yes to set
Check Weighing limits.
Setting Under and Over Limits
The primary display shows UNDER or OVER indicating which
limit is being entered. The secondary display shows the
previous setting or all zeros if no limit was stored (blinking).
Press the Yes button to accept this setting. Press the No
button to edit this setting. The Under limit is the first to be
edited, followed by the Over limit.