EVS IPDirector Version 6.2 - June 2013 INGEST SCHEDULER User Manual - Manual (Page 40)

5.4. Creating Growing Clips
5.4.1. Introduction
A growing clip is an ingest without any OUT point. This type of block has no stop time. It
will continue recording until a user stops it manually.
It displays as follows, on the left of the nowline:
5.4.2. Possible Ways to Start to Record a Growing
Clip
A growing clip can be started in several different ways listed below.
When starting to record a growing clip in one of the following ways, the New Schedule
window will always open with the One-shot tab only and a start time only.
• From the Tree view of the Channel Explorer, right-click a recorder channel and select
Open Ingest Scheduler (new ingest) or Start XT Ingest from the contextual menu.
• From the Recorder view of the Channel Explorer, right-click a recorder channel and
select Open Ingest Scheduler (new ingest) or Start Ingest on Selected Channels
from the contextual menu.
• From the Recorder view of the Channel Explorer, click the Record Now button .
When starting to record a growing clip in one of the two following ways, the New Schedule
window will or will not open, depending on the Autoname Clips setting defined in the
Tools > Settings > Ingest Scheduler > General category. When it opens, only the
One-Shot tab is displayed and a start time is set to the current timecode.
• Click the Start button on the right of the corresponding channel.
• Right-click a track outside a scheduled block and select Start Ingest Now from the
menu.
Note
Only one growing clip may be recorded per recorder channel at a given time.
30 5. Creating Ingests
EVS Broadcast Equipment S.A. - June 2013 Issue 6.2.A