EVS IPDirector Version 6.0 - November 2012 Part 2 User's Manual - Manual (Page 54)

2. Enter a value in one of the TC fields and press ENTER.
3. The field is validated and the other TC values are recalculated.
4. Click OK to confirm or CANCEL to discard changes.
Warning
In this case, new log entries, made after entering the offset, will not have the
offset applied to them. Entering the TC Offset should only be done when the
logsheet is completely finished.
1.9.4. How to Synchronize a Whole Logsheet from a
Loaded Image
The users can apply an offset on a whole logsheet by synchronizing one of the logs to an
image loaded on a player channel. To do so, proceed as follows:
1. Associate a player channel to IPLogger. See section "How to Assign a Player
Channel to IPLogger" on page 25.
2. Open a Control Panel and associate the same player channel to it.
3. Click the log to load it on the player channel.
4. Move through the media until you reach the image actually corresponding to the log.
5. Right-click the log line in the Logsheet grid.
The Log contextual menu is displayed.
6. Select Synchronize this log with the image loaded on the player from the menu.
All the timecodes from the logsheet are reset.
44 1. IPLogger
EVS Broadcast Equipment S.A. - November 2012 Issue 6.00.A