AASTRA 4224 Operator for MX-ONE User Guide - Manual (Page 10)

Description
Dialog 4224 Operator 10
1 Display
5x40 characters. See section “ Display information ” on page 14.
2 On/Off
Switches the operator terminal on or off. Also used to deny more
calls to the terminal. See section “ On/Off duty ” on page 19.
Note: If all operator terminals are in OFF state the exchange
will be switched for Night Service.
3 Meter
To mark an outgoing external line call for metering. See section
“ Recall from a metered call ” on page 55.
4 Serial
Used when an external caller wants to talk to several people in
sequence. The call is automatically recalled to the terminal when
the internal party goes on hook. See section “ Serial calls ” on
page 56.
5 Page
To access the paging capabilities. See sections “ Paging unit ” on
page 44 and “ To paging unit ” on page 80.
6 Alarm
To acknowledge any system alarms. Key lamp flashes slowly at
alarms and shows steady light when the alarm is acknowledged.
See section “ Alarm ” on page 85.
7 Automatic answer
Automatic answer mode. Calls are automatically switched through,
in the received order, without having to press the answer/extend
key. Key lamp shows steady light when automatic answer is
activated. See section “ Manual or automatic answer ” on page 21.
8 Automatic extending
Automatic extend mode. Calls are automatically extended, after the
last entered digit, without having to press the answer/extend key.
Key lamp shows steady light when automatic answer is activated.
See section “ Manual or automatic extending ” on page 22.
9 Continuous ring
Continous ring mode. Incoming calls are signalled with repeated
ring signals. Key lamp shows steady light when continuous ring is
activated.