AASTRA 6700i for OpenCom 1000 User Guide EN - Manual (Page 31)

Configuring the Aastra 673xi / 675xi
27
Configuring the Aastra 673xi / 675xi
Automatic Configuration
The Aastra 6753i, Aastra 6755i and Aastra 6757i SIP telephones support the “Auto-
matic Commissioning / Auto Provisioning” feature. Use this feature to commission
an Aastra 673xi / 675xi without the administrator of the OpenCom 1000 communi-
cations system having to configure it beforehand. Automatic configuration must
be authorised by the administrator of the OpenCom 1000 communications
system.
1. If the Aastra 673xi / 675xi is currently in operation, press the logout function
key and confirm restarting with the OK softkey. If a log-in process was
previously interrupted, press the login softkey.
The Login menu card appears.
2. Use the navigation keys to go to the Callno./ID field.
Enter an unused call number to initiate automatic configuration.
3. Use the navigation keys to go to the PIN field.
Enter the numeric password (PIN) that the administrator of the OpenCom 1000
communications system set up for automatic configuration. Entering the
password is done in the alphanumeric mode. Press a number key multiple
times to reach the desired digit. Enter the digits “00” (and delete these digits if
necessary with the Backspace softkey) to switch into the numeric mode.
4. Confirm using the OK softkey.
The Aastra 673xi / 675xi restarts – it is then configured with a default
configuration for the desired new call number.
Settings
A description of all possible settings of the Aastra 673xi / 675xi can be found in the
user guide of your Aastra 673xi / 675xi telephone (please refer to About this
Manual starting on page 8).
Note
The operation is analogous on the Aastra 6730i / 6731i and on the Aastra 6751i /
6753i. The key assignment is proposed on the bottom display line.