American Magnetics 4Q1005PS-430 Integrated Power Supply System - Manual (Page 189)

Rev. 5 171
Appendix
Model 430 Firmware Upgrade via FTP
15. Click on the ASCII Setup... button and
check the Send line ends with line feeds
box and the Echo typed characters locally
box in the ASCII Sending area. Click on
OK and then OK.
16. Issue commands as
desired. See “Remote
Interface Reference”
on page 93.
A.13 Upgrading the Model 430 Firmware via FTP
Note
IMPORTANT If the Model 430 is being upgraded from Version 1.59
or earlier, proceed to the upgrade procedure in section A.14 on
page 178.
Note
These instructions apply specifically to the Windows XP operating
system. For other operating systems, please make adjustments as
appropriate.
A.13.1 Hardware and Software Requirements
1. Personal Computer (PC) networked by Ethernet to the system on
which the target Model 430 resides,
or
PC connected directly to the target Model 430 via a “null-modem”
or “crossover” Ethernet cable.