American Magnetics 4Q1005PS-430 Integrated Power Supply System - Manual (Page 134)

116 Rev. 5
Remote Interface Reference
SETUP Configuration Commands and Queries
•
CONFigure:LOCK:PSwitch:CONTRol {0|1}
Specifies whether use of the PERSIST. SWITCH CONTROL key is locked
or unlocked. Sending “0” unlocks. A “1” locks. “0” is the default value.
•
LOCK:PSwitch:CONTRol?
Returns “0” for use of the PERSIST. SWITCH CONTROL key unlocked, or
“1” for locked.
•
CONFigure:LOCK:TARGet {0|1}
Specifies whether use of the TARGET FIELD SETPOINT key is locked or
unlocked. Sending “0” unlocks. A “1” locks. “0” is the default value.
•
LOCK:TARGet?
Returns “0” for use of the TARGET FIELD SETPOINT key unlocked, or “1”
for locked.
•
CONFigure:LOCK:RAMP-PAUSE {0|1}
Specifies whether use of the RAMP / PAUSE key is locked or unlocked.
Sending “0” unlocks. A “1” locks. “0” is the default value.
•
LOCK:RAMP-PAUSE?
Returns “0” for use of the RAMP / PAUSE key unlocked, or “1” for locked.
•
CONFigure:LOCK:ZEROfield {0|1}
Specifies whether use of the RAMP TO ZERO key is locked or unlocked.
Sending “0” unlocks. A “1” locks. “0” is the default value.
•
LOCK:ZEROfield?
Returns “0” for use of the RAMP TO ZERO key unlocked, or “1” for locked.
•
CONFigure:LOCK:RAMPrate {0|1}
Specifies whether ramp rate settings are locked or unlocked. Ramp rate
settings protected by this setting are: use of the RAMP RATE SHIFT-key
menu, editing of the Ramp Segments value (under the Misc submenu) and
editing of the Ramp Time Units value (under the Misc submenu). Sending
“0” unlocks. A “1” locks. “0” is the default value.
•
LOCK:RAMPrate?
Returns “0” for ramp rate settings unlocked, or “1” for locked.
•
CONFigure:LOCK:SUPPly {0|1}
Specifies whether the Select Supply picklist value is locked or unlocked. If
the Select Supply value is Custom..., then setting Power Supply Lock to
Locked also prevents the custom power supply parameters (Min Output
Voltage, Max Output Voltage, Min Output Current, Max Output Current