American Magnetics 12200PS DC Power Supply (CE-Marked) - Manual (Page 18)

OPERATING MANUAL INSTALLATION
Release 1.0 (98/07) 2-3
2.3.1 Initial Inspection (continued)
Figure 2.3-2 Power Supply Rear Panel
(Bus bar output model (7.5V to 100V) shown.)
Blank Subplate
(Replaced if digital
programming
interface
J10 Sense Connector
(See Section 2.8 for more
information.)
1 Return Sense
2 Negative Output (Return)
3 No connection (N/C)
4 Positive Output
5 Positive Sense
J2 Programming and Monitoring Connector
(See Section 4.2 for more information.)
1 Remote Output Voltage Programming Select
2 Remote Output Current Limit Programming Select
3 Control Ground
4 N/C
5 Voltage Program Signal Return
6 Output Voltage Program Input
7 Current Program Signal Return
8 Output Current Limit Programming Input
9 Voltage Monitor Signal Return
10 Output Voltage Monitor
11 Current Monitor Signal Return
12 Output Current Monitor
13 N/C
14 Shutdown (S/D) Signal Return (-)
15 S/D Input (+)
SW1 Switch (See Section 4.2 for more information.)
1 Resistive Programming of Output Voltage
2 Resistive Programming of Output Current Limit
3 Output Voltage Programming Source Range
4 Output Current Limit Programming Source Range
5 Output Voltage Monitor Range
6 Output Current Monitor Range
7 Remote Shutdown Logic
8 Over Temperature Reset Mode
Fan Exhaust Vents
(Do not obstruct.)
AC Input
Connector
(See Section 2.5
for more
information.)
DC Output
(See inset and
Section 2.7 for
more information.)
Output Voltage Connector
For high voltage (150V to 600V)
models.