Installing the batteries – Garmin GPSMAP 60CSx User Manual
Page 12
GPSMAP 60CSx Owner’s Manual
g
ettIng
s
tArted
>
u
nIt
o
vervIew
Installing the Batteries
The GPSMAP 60CSx operates on two AA batteries
(not included), which are located in the back of the
unit. You can use Alkaline or NiMH batteries. See
to set the battery type.
To install the batteries:
1. Remove the battery
cover by turning the
D-Ring 1/4 turn counter-
clockwise and pulling the
cover loose.
2. Insert the batteries,
observing the proper
polarity. A polarity
diagram is molded into
the battery compartment.
3. Reinstall the battery
cover by aligning the
back cover with the unit and turning the D-Ring
1/4 turn clockwise.
Remove the batteries from your GPSMAP 60CSx
when you do not expect to use the unit for several
months. Data is not lost when batteries are removed.
Note: Lithium batteries are not recommended
because the initial voltage of new batteries may
exceed 1.5 volts each, which may cause the
GPSMAP 60CSx to turn off.
To install the Lanyard:
1. Place the loop of the Lanyard through the slot
at the at the upper left side of the unit.
2 Route the strap through the loop and pull tight.
Wrist Strap
Installation
Refer to
for information on accessing the
microSD data card in the battery compartment.
USE BY
2009
USE BY
2009
Battery
Compartment
USE BY
2009
USE BY
2009
Battery
Compartment