Garmin GPSMAP 168 Sounder User Manual
Page 98
87
Appendix C
Messages
Proximity Alarm List is Full— You have used all ten proximity
waypoints.
Proximity Alarm Waypoint— You have entered the alarm radius for the
proximity waypoint indicated.
Proximity Overlaps Another Proximity Waypoint—The alarm radius speci-
fi ed overlaps the area specifi ed for another proximity waypoint. Adjust the
distance.
Route Already Exists:
already exists in memory. Modify the route name or delete the previous route
name.
Route Does Not Exist:
from memory and cannot be used.
Route Is Full— You have attempted to add more than 30 points to a route.
Reduce the number of points or create a second route.
Route Memory Is Full Can’t Create Route— Maximum amount of 20 routes
is already in the unit’s memory and no additional routes can be added until
existing ones are removed.
Route Truncated— An uploaded route from another device has more than 30
points. Reduce the number of points.
Running Simulator— The unit is in simulator (practice) mode.
Shallow Water Alarm— Specifi ed shallow water alarm depth has been
detected below transducer.
Sonar Failed Unit Needs Repair— Internal problem with the unit. Contact
your dealer or GARMIN Customer Service (page. iv) to have the unit serviced.
Track Already Exists:
Track Memory Is Full Can’t Create Track— Track log memory is full.
No additional track log data can be stored without deleting old data to
create memory space.
Track Truncated— A complete uploaded track will not fi t into memory.
The oldest track log points were deleted to make space for the most
recent data.
Transducer Disconnected Sonar Turned Off— No transducer attached
or bad cable/transducer.
Transfer Complete— The unit has fi nished uploading/downloading
information to the connected device.
Water Speed Sensor is Not Working— Speed sensor is not detected.
Check connections.
Waypoint Already Exists:
waypoint name that already exists in memory. Modify the waypoint name
or delete the previous waypoint name.
Waypoint Memory Is Full Can’t Create Waypoint— You have used
all 500 waypoints available. Delete unwanted waypoints to make space
for new entries.
168 Manual Part 2.indd 87
11/18/2002, 3:38:10 PM