Garmin GPSMAP 7215 - Manual (Page 113)

GPSMAP ® 6000/7000 Series Owner’s Manual 107
Sonar
• For the GPSMAP 7000 series, use the on-screen keyboard.
3. Select Done .
Setting the Fish Alarm
Note: This feature is available only on the GSD 22.
You can set an alarm to sound when the chartplotter detects a suspended target of the specified size.
1. From the Home screen, select
Configure > Alarms > Sonar > Fish .
2. Complete an action:
• Select to sound an alarm for all fish sizes.
• Select to sound an alarm for medium and large fish only.
• Select to sound an alarm for large fish only.
Setting the Contour Fish Alarm
Note: This feature is available only on the GSD 24 and GSD 26.
You can set an alarm to sound when the chartplotter detects a suspended target within the specified depth range
and the specified color range.
1. From the Home screen, select
Configure > Alarms > Sonar > Fish > Contour .
2. Select top .
3. Enter a distance from the top to show an alarm for targets near the surface:
• For the GPSMAP 6000 series, use the Rocker or Numeric Keypad.
• For the GPSMAP 7000 series, use the on-screen keyboard.
4. Select Done .
5. Select Bottom .
6. Enter a distance to the bottom to sound an alarm for targets near the bottom of the water:
• For the GPSMAP 6000 series, use the Rocker or Numeric Keypad.
• For the GPSMAP 7000 series, use the on-screen keyboard.
7. Select Done .
8. Select Intensity .
9. Select a color, and select Back .
Setting the Bottom Fish Alarm
Note: This feature is available only on the GSD 24 and GSD 26.
You can set an alarm to sound when the chartplotter detects a suspended target within the specified range from
the bottom and the specified color range.
1. From the Home screen, select
Configure > Alarms > Sonar > Fish > Bottom .
2. Select Span .
3. Enter a distance to the bottom to sound an alarm for targets near the bottom of the water:
• For the GPSMAP 6000 series, use the Rocker or Numeric Keypad.
• For the GPSMAP 7000 series, use the on-screen keyboard.
4. Select Done .
5. Select Intensity .
6. Select a color, and select Back .
Transducer Configuration
Setting the Keel Offset
The keel offset compensates for the surface reading for the depth of a keel, making it possible to measure
depth from the bottom of the keel instead of from the transducer location. Enter a positive number to offset for
a keel. You can enter a negative number to compensate for a large vessel that may draw several feet of water.