Acura 2011 TSX - Manual (Page 114)

Operating the Switches Around the Steering Wheel Driving Position Memory System*
112
C
o
nt
ro
ls
1. Adjust the driver's seat to the desired
position, and turn the ignition switch to
ON II .
2. Press the SET button.
You will hear the beeper, and the
memory button indicator light will blink.
3. Press memory button 1 or 2 within five
seconds of pressing the SET button.
Once the seat position has been
memorized, the indicator light on the
button you pressed stays on.
Storing a Position in Memory
Automatic transmission models
1. Move the shift lever to P .
All models
2. Apply the parking brake.
3. Press a memory button ( 1 or 2 ).
You will hear the beeper, and the
indicator light will blink.
The seat will automatically move to the
memorized position. When it has finished
moving, you will hear the beeper, and the
indicator light stays on.
Recalling the Stored Position
Storing a Position in Memory
After you press the SET button, the storing
operation will be canceled when:
You do not press the memory button within five •
seconds.
You readjust the seat position before the double-
•
beep.
You turn the ignition switch to any position
•
except ON II .
Recalling the Stored Position
The seat will stop moving if you:
Press the SET button, or a memory button ( • 1 or
2 ).
Adjust the seat position. •
Automatic transmission models
Shift into any position except • P .
Manual transmission models
Release the parking brake. •
Memory Button 1
Memory Button 2
Set Button
Memory Buttons
31TL1620.indb 112 2010/09/10 16:13:09