ACR&Artex C406-2 HM - Manual (Page 62)

ACR ELECTRONICS, INC / ARTEX PRODUCTS
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
C406-2 (453-5000), C406-2HM (453-5001)
25-62-11
Page 62 of 87
JUN 20/13
TASK 25-62-11-450-804
5. Buzzer
SUBTASK 25-62-11-450-001
A. Location
CAUTION: PLACING THE BUZZER IN THE COCKPIT IS NOT RECOMMENDED DUE TO THE
POTENTIAL FOR DISTRACTION. THE BUZZER PRODUCES A LOUD, SIREN-TYPE
SOUND WHEN THE ELT IS ACTIVATED. SINCE THE BUZZER OPERATES IN TANDEM
WITH THE COCKPIT LED, IT WOULD ONLY SERVE AS A REDUNDANT WARNING
INDICATOR IN THE COCKPIT.
(1) Select a suitable location for the buzzer.
NOTE: The buzzer may be located anywhere in the aircraft; however, the recommended
location is near the ELT, as the buzzer is loud enough to be heard outside the aircraft
when the engine(s) is not running. When the engine(s) is running, the LED on the
cockpit remote switch assembly will warn the pilot the ELT is active.
SUBTASK 25-62-11-450-002
B. Installation
(1) Fabricate a bracket suitable for supporting the buzzer. See Figure 19.
NOTE: Refer to the aircraft manufacturer’s written instructions or AC 43.13-2, as applicable,
for approved bracket fabrication and installation methods.
Figure 19 Buzzer Outline and Dimensions
(2) Attach the bracket to the airframe such that the buzzer is adequately supported and does not
show any significant evidence of distorting the airframe skin.
(3) Install the buzzer in the bracket.
(a) Remove the panel mounting nut and insert the buzzer in the bracket.
(b) Install the panel mounting nut and tighten it securely.
+
ARTEX
+ -
-
1.68
(43)
1.75
(45)
1.115
(28.3)
PANEL MOUNTING NUT
0.445
(11.3)
FRONT VIEW SIDE VIEW REAR VIEW Dimensions are
reference only
130-4004