Rmc 5018 – Acnodes RMC 5018 User Manual

Page 63

RMC 5018

1U Rackmount System

All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909.597.1939

XAdvanced Chipset Control

The items included in the Advanced Settings submenu are listed below:

XNorthBridge Configuration

This feature allows the user to configure the settings for the Intel 945GC North- Bridge.

DRAM Frequency

This feature allows the user to select the DRAM Frequency setting. The options are Auto (Auto-detect),
400 MHz and 533 MHz.

Configure DRAM Timing by SPD

Select Enable to allow the BIOS to read the SPD (Serial Presence Detect) chip which is built in the
memory module in order to get the exact memory specifica- tions. The options are Enabled and Dis-
abled.

DRAM CAS# Latency

The options are [3], [4], [5], and [6]

DRAM RAS# to CAS# Delay

The options are 3 DRAM Clocks, 4 DRAM Clocks, 5 DRAM Clocks, and 6 DRAM Clocks.

DRAM RAS# Precharge

The options are 3 DRAM Clocks, 4 DRAM Clocks, 5 DRAM Clocks, and 6 DRAM Clocks.

DRAM RAS# Activate to Precharge

The options are 9 DRAM Clocks, 10 DRAM Clocks, 11 DRAM Clocks, 12 DRAM Clocks, 13 DRAM
Clocks, 14 DRAM Clocks, and 15 DRAM Clocks.

Initiate Graphic Adapter

Use the feature to select the graphics controller to be used as the primary boot device. The options
are IGD, PCI/IGD, PCI/PEG, PEG/IGD, and PEG/PCI.

Internal Graphics Device Mode Select

Use the feature to set the amount of system memory to be used by the Internal Graphics Devices. The
options are Disabled, Enabled, 1 MB and Enabled, 8 MB.