STIEBEL ELTRON HDB-E Si 01.11.2012 - 31.01.2013 - Manual (Page 16)

16 | HDB-E Si www.stiebel-eltron.com
CONTENTS | OPERATION
General information
OPERATION
1. General information _______________________________________ 16
1.1 Safety instructions ______________________________________________ 16
1.2 Other symbols in this documentation ______________________ 17
1.3 Units of measurement _________________________________________ 17
2. Safety ________________________________________________________ 17
2.1 Intended use _____________________________________________________ 17
2.2 General safety instructions ___________________________________ 17
2.3 CE designation __________________________________________________ 17
2.4 Test symbols _____________________________________________________ 17
3. Appliance description _____________________________________ 17
4. Operation ___________________________________________________ 18
5. Cleaning, care and maintenance _________________________ 18
6. Troubleshooting ____________________________________________ 18
INSTALLATION
7. Safety ________________________________________________________ 19
7.1 General safety instructions ___________________________________ 19
7.2 Regulations, standards and instructions ___________________ 19
8. Appliance description _____________________________________ 19
8.1 Standard delivery _______________________________________________ 19
8.2 Accessories _______________________________________________________ 19
9. Preparations ________________________________________________ 19
9.1 Installation site __________________________________________________ 20
9.2 Factory settings _________________________________________________ 20
10. Installation __________________________________________________ 20
10.1 Completing the installation ___________________________________ 22
10.2 Alternative installation methods_____________________________ 22
11. Commissioning _____________________________________________ 24
11.1 Commissioning __________________________________________________ 24
11.2 Recommissioning _______________________________________________ 24
12. Shutting down ______________________________________________ 24
13. Troubleshooting ____________________________________________ 24
13.1
Display options for LED diagnostic traffic light ___________ 24
13.2 Fault table ________________________________________________________ 25
14. Maintenance ________________________________________________ 25
15. Specification ________________________________________________ 26
15.1 Dimensions and connections _________________________________ 26
15.2 Wiring diagram _________________________________________________ 26
15.3 Mixed water volume / outlet volume _______________________ 26
15.4 Application areas _______________________________________________ 27
15.5 Pressure drop ___________________________________________________ 27
15.6 Fault conditions _________________________________________________ 27
15.7 Data table ________________________________________________________ 27
WARRANTY | ENVIRONMENT AND RECYCLING
Operation
1. General information
The chapter “Operation” is intended for appliance users and heat-
ing contractors.
The chapter “Installation” is intended for heating contractors.
Note
Read these instructions carefully before using the appli-
ance and retain them for future reference.
Pass on the instructions to a new user if required.
1.1 Safety instructions
1.1.1 Structure of safety instructions
!
KEYWORD Type of risk
Here, possible consequences are listed that may result
from failure to observe the safety instructions.
f Steps to prevent the risk are listed.
1.1.2 Symbols, type of risk
Symbol Type of risk
Injury
Electrocution
Burns
(burns, scalding)
1.1.3 Keywords
KEYWORD Meaning
DANGER Failure to observe this information will result in serious
injury or death.
WARNING Failure to observe this information may result in serious
injury or death.
CAUTION Failure to observe this information may result in non-
serious or minor injury.
!