RIDGID SeeSnake - Manual (Page 11)

Ridge Tool Company 0
Tools For The Professional TM
SeeSnake ®
The system is set by default to Standard Play.
The Recording menu also lets you set a value for chapter
length when recording. The default value is 5 minutes, and
it can be changed to make chapters of 10, 15, 20, 25 or
30 minutes. Chapter marking occurs while recording but
does not interrupt the recording process.
Black & White SeeSnake
Capacity
- Regular SeeSnake: 50 to 300 mm, max. 99 m length
- Mini SeeSnake: 40 to 150 mm, max. 61m length
Operation
See section colour Mon VCR.
CountIR (Fig. 7)
All SeeSnake reels are equipped with a CountIR. The
CountIR measures the distance the camera is in the pipe.
Key pad usage
The CountIR has three buttons
A. Distance: the distance is displayed in the lower right
hand corner of screen.
To remove distance reading press once, press again to
show distance reading.
B. Zero: Resets distance reading to zero.
C. Clock: Displays date and time. Press to choose both, one
or none displayed. Press and hold to display optional title
field.
Edit mode
Press distance and clock simultaneously to get into edit
mode.
A. Distance: Functions as edit button. Press to cycle through
available options.
B. Zero: Functions as next button. Press to move to next
field.
C. Clock: Functions as exit button. Press to exit from edit
mode, saving any changes made.
Menu fields
Time: 12 hr (AM/PM) or 24 hr
Date: mm/dd/yy or dd/mm/yy
Units: feet or metres
Title: title is factory set to RIDGID Kollmann but can be
changed to any title up to 18 characters. Press edit to scroll
through the letters and symbols.
Cable length: Important: Press distance and clock at the
same time to edit SeeSnake type
and cable length.
Select the actual push cable
length for your SeeSnake.
The selection for length is from
15 to 100 metres in 1-metre
increments.
SeeSnake
System: Select type of SeeSnake system, either Mini or
Standard.
Battery removal/installation
1. The CountIR uses a single Lithium CR-2032, 3 volt
battery.
2. The battery is located inside the CountIR.
3. When the battery is removed all of the Edit menu fields
and system setting are lost and will need to be individually
reentered. The battery should last for approximately
5 years.
4. Before inserting a new CR-2032 battery make sure the
polarity is correct.
Insert the battery such that the (+) side of the battery is
towards the top of the battery holder (this is also towards the
center of the CountIR.
Possible display messages
Error 1: Displayed when the CountIR reads a distance
which is beyond limits.
These limits could be less than zero or a length that
is 12 m greater than what the system is configured
for.
Error 2: Displayed when the system memory is not set
up. This can occur when the battery needs to be
replaced.
No Video: Displayed when the camera is disconnected. Once
the camera is reconnected, the screen is restored.