3Com 3C840 - Manual (Page 197)

Instructions for Telecommuting / Remote Office Access E-7
4 Press the Modify button before leaving this screen to save the changes.
5 If you are also going to configure the router for Telecommuting / Remote
Office Access, continue to the next section. Otherwise, go to Using the
Configuration Audit.
Instructions for
Telecommuting /
Remote Office
Access Before you configure your OfficeConnect Remote 840 to access a remote
office, make sure you have completed the Telecommuting/Remote Access
Planning Form from Chapter 1 of the Installation Guide by entering
information from your remote site network administrator.
Step 1: Configuring
Remote Site General
Information
Add a remote site by going to the OfficeConnect Remote 840 home
page.
1 Add a remote site by going to the OfficeConnect Remote 840 home
page. Select Configuration > Remote Sites (WAN) > Add.
If your unit is using Frame Relay, this will access the Remote Sites General
Add screen, containing the following fields:
■
Enter a name to identify the remote site.
■ Set Network Service to PPP over Frame Relay or RFC 1490.
840ug.book Page 7 Friday, July 7, 2000 2:23 PM