Xerox 701P42722_EN - Manual (Page 88)

10 IPP (Internet Printing Protocol)
88 Xerox CopyCentre/WorkCentre 118 System Administration Guide
NOTE: Use the DHCP server together with the Windows Internet Name Service
(WINS) server.
If you selected [Manual] in step 4, use the following steps to enter the IP address.
If you selected other than [Manual], press the button and then go to
Workstation Setup on page 88.
1. Press the button.
2. Select [IP Address] by selecting [ T] or [S] and then press the button.
3. Use the numeric keypad to enter the IP address in the format “xxx.xxx.xxx.xxx”.
NOTE: Press the < J> button to move to the next section. Press the button to
return to the previous section.
NOTE: You cannot enter 127, 254, or 255 into the first section of the format.
4. Press the button.
5. Press the button.
6. Use the same steps as IP address setting to enter the subnet mask and gateway
address.
NOTE: You can enter 000, 128, 192, 224, 240, 248, 252, 254, or 255 into each section
as the values for the subnet mask.
NOTE: You cannot enter 127, 254, or 255 into the first section of the format for the
gateway address.
7. Press the button.
NOTE: If you wish to filter access to the machine from the client computers, activate
the IP Filter. The [Filter] screen is located in the same layer as the [TCP/IP Settings]
screen.
Workstation Setup
For each client workstation that will be sending print jobs to the machine, install the print
drivers for the machine, and map to the machine as a printer. Refer to the HTML
documentation in CentreWare Utilities CD-ROM, for additional information.
Test Print
To make sure that the machine has been installed on the network correctly a test print
should be submitted from a client workstation. Perform the following steps.
1. Open a document on a client workstation.
2. Select the machine as the printer to which the selected document will be sent.
3. Print the document on the machine and verify that it prints correctly.