Xerox 701P42722_EN - Manual (Page 35)

NetWare Installation
Xerox CopyCentre/WorkCentre 118 System Administration Guide 35
NetWare Installation
This section describes the installation procedures to use the machine in a NetWare
environment.
Installation Procedure
The installation procedure is as follows.
Network Communication Setup
For more information, refer to Network Communication Setup on page 35.
NetWare Setup
For more information, refer to NetWare Setup on page 37.
Workstation Setup
For more information, refer to Workstation Setup on page 37.
Test Print
For more information, refer to Test Print on page 37.
Network Communication Setup
Use this procedure to set up the network communication parameters of the machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
NOTE: CentreWare Internet Services can also be used to configure the machine.
Refer to CentreWare Internet Services chapter on page 91.
First, enable the NetWare port.
1. Connect the machine to the network.
2. Press the button.
3. Select [System Settings].
4. Enter the password using the numeric keypad and then select [Confirm].
5. Select [Print Settings] and then press the button.
6. Press the button on the [Network/Port] screen.
7. Select [NetWare] by selecting [
T] or [S] and then press the button.
8. Select [Port Status] by selecting [
T] or [S] and then press the button.
9. Select [Enable] by selecting [
T] or [S] and then press the button.