Xerox 701P42722_EN - Manual (Page 36)

3 NetWare
36 Xerox CopyCentre/WorkCentre 118 System Administration Guide
If necessary, you may change the following settings.
• Transport Protocol
• Print Mode
• PJL
• Number of searches
Next, establish TCP/IP if you use an IP address for a NetWare network.
If IP address setting is unnecessary, press the button to go to NetWare
Setup on page 37.
1. Press the button once or twice to display the [Network/Port] screen.
2. Select [TCP/IP Settings] by selecting [ T] or [S] and then press the
button.
3. Select [Get IP Address] by selecting [
T] or [S] and then press the
button.
4. Select [DHCP/Autonet], [DHCP], [BOOTP], [RARP], or [Manual] by selecting [
T]
or [ S] and then press the button.
NOTE: Use the DHCP server together with the Windows Internet Name Service
(WINS) server.
If you selected [Manual] in step 4, use the following steps to enter the IP address.
If you selected other than [Manual], press the button and then go to
Workstation Setup on page 37.
1. Press the button.
2. Select [IP Address] by selecting [ T] or [S] and then press the button.
3. Use the numeric keypad to enter the IP address in the format “xxx.xxx.xxx.xxx”.
NOTE: Press the <
J> button to move to the next section. Press the button to
return to the previous section.
NOTE: You cannot enter 127, 254, or 255 into the first section of the format.
4. Press the button.
5. Press the button.
6. Use the same steps as IP address setting to enter the subnet mask and gateway
address.
NOTE: You can enter 000, 128, 192, 224, 240, 248, 252, 254, or 255 into each section
as the values for the subnet mask.
NOTE: You cannot enter 127, 254, or 255 into the first section of the format for the
gateway address.
7. Press the button.