Workstation setup – Xerox 701P42722_EN User Manual

Page 42

4 UNIX TCP/IP

Xerox CopyCentre/WorkCentre 118 System Administration Guide

Use the same steps as IP address setting to enter the subnet mask and gateway
address.

NOTE: You can enter 000, 128, 192, 224, 240, 248, 252, 254, or 255 into each section
as the values for the subnet mask.

NOTE: You cannot enter 127, 254, or 255 into the first section of the format for the
gateway address.

Press the button.

NOTE: If you wish to filter access to the machine from the client computers, activate
the IP Filter. The [Filter] screen is located in the same layer as the [TCP/IP Settings]
screen.

Workstation Setup

This section explains how to change the workstation OS for Solaris, SunOS, and HP-
UX workstations. Refer to the relevant instructions below.

Solaris – page 44
SunOS – page 44
HP-UX – page 46

Print language/mode/logical printer

A printer name for logical printer should correspond to the print language/mode to be
used for printing, or to the Logical Printer Number which was registered through
CentreWare Internet Services.

Printer Name

Print Language/Mode/Logical Printer

PS*

PostScript

PSASC/PSA*

PostScript

PSBIN/PSB*

PostScript

PCL

Print language which was specified on the
touch screen of the machine.

DUMP/DMP

Dump mode

AUTO/ATO

Auto detection mode

TIFF/TIF

TIFF direct print

TIFF%n

TIFF (%n: Logical Printer Number 1 to 10
which were registered through CentreWare
Internet Services.)

PS%n*

PostScript (%n: Logical Printer Number 1 to
10 which were registered through
CentreWare Internet Services.)