Xerox 701P42722_EN - Manual (Page 81)

Xerox CopyCentre/WorkCentre 118 System Administration Guide 81
9 USB Port
This chapter explains how to set up the machine in a USB port environment. The
following information is provided.
Information Checklist – page 81
USB Port Environment – page 82
USB Port Installation – page 82
Installation Procedure – page 82
USB Port Communication Setup – page 83
Workstation Setup – page 83
Test Print – page 84
Information Checklist
Before starting the USB port installation procedures, make sure that the following items
are available or have been performed.
NOTE: The installation procedures will install the machine on the USB port of the host
workstation. The procedures are not intended to connect the host workstation to other
workstations.
If problems are encountered during the installation of the machine, refer to the Problem
Solving chapter for assistance.
CAUTION: Do not connect the USB cable to the machine until instructed to do so.
Item By
USB Cable Customer
Test the machine to make sure that it is installed fully and functioning
correctly. Customer
Print driver for the machine Customer