Xerox NS-2260 - Manual (Page 95)

5.3 Port status
This page shows all port status in a scroll bar list. The status are dependent on user settings and the
negotiation results as follows:
State : Display port function status including -
Config : function setting - On = enable, Off = disable
Atual : status - On = enabled, Off = disabled
Link Status : Down = No Link, UP = active link is established
Auto Negotiation : Display the auto negotiation mode setting and status
Config / Atual
Auto = enable auto negotiation with the specified highest capability
Force = disable auto negotiation and use forced mode
Nway-force = enable auto negotiation with the specified capability
Note : Specified capability means speed and duplex configuration
Speed status : Display port speed setting and status
Config : port speed capability setting
Atual : port speed is used currently
Port 1-24 : 10/100Mbps
G1 port, G2 port : 10/100/1000Mbps
Duplex status : Display duplex setting and status
Config : port duplex capability setting - Full, Half
Atual : port duplex mode is used currently - Full, Half
Flow Control: Display the flow control settings and status
Config/Full : On = enable for full duplex, Off = disable