Xerox NS-2260 - Manual (Page 89)

4.1 Configuring SNMP Settings via Console Operation
Before performing SNMP operation, proper SNMP settings must be configured. The SNMP related settings
are:
Name : Logic name to identify the switch unit
Location : Location where the switch unit is installed
Contact : Contact person regarding the switch unit
Community string : SNMP communities to which the SNMP manager belongs and access right to the
switch unit ( read only or read/write)
Trap Managers : IP addresses of trap managers to which a trap is
issued and the community to which the trap manager belongs.
Up to four SNMP communities and up to three trap managers are supported by the system SNMP agent.
4.2 SNMP MIB-2 and Private MIB
Use the SNMP management application software to compile the MIB file first before performing any management operation. The
following MIB standards are supported:
RFC1213 MIB-2
RFC1493 Bridge MIB
RFC1643 Ethernet-like MIB
RFC1271 RMON MIB statistics, history, alarm, event group
Private MIB (Device Specific)
The following MIB-2 objects are related to the switched ports and are indexed by a port number 1 ~ 27 (27
= CPU port):
Port MIB-2 Objects
Set/Get Value Options
ifIndex.1 ~ 27 Get Physical port number
ifDescr.1 ~ 26 Get text - Port 1~26 on unit 1
ifDescr.27 Get text - ethernet switch low driver
ifType.1 ~ 27 Get erhernet-csmacd(6)
ifSpeed.1 ~ 24 Get 100000000=100M, 10000000=10M
ifSpeed.25 ~ 26 Get 100000000=100M, 10000000=10M
1000000000=1000M, 0=No module
ifSpeed.27 Get 10000000 = 10M
ifAdminStatus.1 ~ 27 Set up(1) = enable port
down(2) = disable port
ifAdminStatus.1 ~ 27 Get up(1) = port is enabled
down(2) = port is disabled
ifOperStatus.1 ~ 27 Get up(1) = port status link up
down(2) =port status link down
ifLastChange.1 ~ 27 Get Time of port status change
ifInOctets.1 ~ 27 Get Port total bytes received
ifInUcastPkts.1 ~ 27 Get Port total unicast packet received
ifInNUcastPkts.1 ~ 27 Get Port total non-unicast packet received
ifInDiscards.1 ~ 27 Get Port total packet dropped
ifInErrors.1 ~ 27 Get Port total error packet received
ifOutOctets.1 ~ 27 Get Port total bytes sent
ifOutUcastPkts.1 ~ 27 Get Port total unicast packet sent
ifOutNUcastPkts.1 ~ 27 Get Port total non-unicast packet sent
ifOutDiscards.1 ~ 27 Get Port total packet aborted
ifOutErrors.1 ~ 27 Get Port total error packet sent
ifOutQLen.11 Get Port total output queued packets