Xerox NS-2260 - Manual (Page 147)

Appendix A: Factory Default Settings
IP Address Related Settings
DHCP Disabled
Static IP Address 192.168.0.2
Subnet Mask 255.255.255.0
Default Gateway 192.168.0.1
Per Port Settings
Port Function Enabled
Auto -negotiation Auto
Speed 100Mbps (Port 1-Port 24)
1000Mbps (Port G1, G2)
Duplex Full (All ports)
Flow Control / Full Enabled
Flow Control / Half Enabled
Ingress Rate Control 0 - Off
Egress Rate Control 0 - Off
Port Security Off
Switch Unit Related Settings
User Name Admin
Password 123
Age -out Time 300 seconds
Max. Bridge Transmit Delay Bound Off
Enable Low Queue Delay Bound Off
Max. Low Queue Delay Bound 255 (2ms/unit)
Broadcast Storm Filtering 25%
Collision Retry Forever Disabled
Hash Method CRC-Hash
802.1x Protocol Enabled
Trunking No trunk group
IGMP Enabled
Static MAC Address None
Filter MAC Address None
Port Sniffer Function Disabled
QoS Priority Settings
Port Priority Disabled ( All ports )
802.1p Priority Level Low priority for Level 0~3
High priority for Level 4-7
Priority Queue Service Mode All High before Low
VLAN Settings
VLAN Mode No VLAN
Port -based VLAN No group (if enabled)
802.1Q VLAN GVRP enabled
802.1Q VLAN Groups All ports in VID=1 Vlan Name=Default
Tag rule = Untag for all member ports
PVID = 1, Protocol type : None
Ingress Filtering Rule 1 : enabled
Ingress Filtering Rule 2 : disabled
Spanning Tree Protocol Settings
STP Function Disabled
Bridge Priority 32768
Bridge Max. Age 20
Hello Time 2