Xerox NS-2260 - Manual (Page 74)

3.4.5.2 State Activity
-------------------------------------------------------------------------
Managed 24+2G Switch : LACP Port Active State Configuration
Port State Activity Port State Activity
---------------------------- -----------------------------
1 Active 14 Passive
2 Active 15 Passive
3 Active 16 Passive
4 Active 17 Passive
5 Passive 18 Passive
6 Passive 19 Passive
7 Passive 20 Passive
8 Passive 21 Passive
9 Passive 22 Passive
10 Passive 23 Passive
11 Passive 24 Passive
12 Passive 25 Passive
13 Passive 26 Passive
action->
-------------------------------------------------------------------------
Use >.command to set LACP state activity mode for each port.
State Activity setting options -
Active : The port automatically sends LACP protocol packets. If it belongs to a trunk group which is set to
LACP mode.
Passive : The port does not automatically send LACP protocol packets and responds only if it receives
LACP protocol packets from the opposite device.
Note:
If a trunk group is set to LACP mode, all its member ports are set to [Active] default.