Xerox NS-2260 - Manual (Page 37)

3. Console and Telnet Operation
This chapter describes the detailed console operation. It can be applied to either out-of-band console
management or in-band Telnet management. Refer to Chapter 2 for installation details.
Cold Start
When the power to the switch is turned on, the device start initialization and self-test process. The self-test
messages are displayed as follows if a console connection is established successfully.:
Power-on Self-test Console message
---------------------------------------------
$$$ Switch LOADER Checksum O.K !!!
$$$ Press any key to start Xmodem receiver:
$$$ Switch IMAGE Checksum ...... O.K !!!
$$$ Loading IMAGE ...............................
$$$ Switch Power On Self Test...
$$$ CPU(arm7) Sdram Test Start..
++ Memory Test (Long) .... O.K !!!
++ Memory Test (Short) ... O.K !!!
++ Memory Test (Byte) .... O.K !!!
$$$ CPU(arm7) Sdram Test O.K !!!
$$$ Switch Register R/W Test ...O.K !!!
$$$ Phy Register R/W Test ...O.K !!!
$$$ Embedded Sram Built In Self Test ...O.K !!!
$$$ Switch Data Area Checksum ...O.K !!!
$$$ Detect Module Card... O.K !!!
$$$ Switch Engine Initialize...O.K !!!
$$$ Trunk Initialize...O.K !!!
$$$ Port Initialize...O.K !!!
$$$ BwCtrl Initialize...O.K !!!
$$$ Forwarding Initialize...O.K !!!
$$$ Vlan Initialize...O.K !!!
---------------------------------------------
Both console management and Telnet management are same in operation starting from login prompt.