Xerox PE220 - Manual (Page 168)

9 Troubleshooting
9-10 Xerox PE220
Memory Full The memory is full. Delete unnecessary documents
and retransmit after more
memory becomes available.
Alternatively, split the
transmission into more than one
operation.
No Answer The receiving fax
machine has not
answered after several
redial attempts. Try again. Make sure that the
receiving machine is
operational.
No Cartridge
Detected The print cartridge is
not installed. Install the print cartridge. See
Installing the Smart Kit ®
Print Cartridge on page 2-4
.
Not Assigned The speed dial location
you tried to use has no
number assigned to it.
The ID you entered is
not assigned.
Dial the number manually using
the number keypad or assign
the number. For storing a
number, see
Automatic
Dialing on page 7-14 .
Enter the correct ID. .
No Paper
Add Paper The paper in the tray
has run out. Load paper in the tray. See
Loading Paper on page 2-6 .
Operation
Not Assigned You are doing the Add/
Cancel operation, but
there are no jobs
waiting. Check the display to see if there
are any scheduled jobs. The
display should indicate them in
Standby mode; for example,
Delay Fax.
Out of Range The current date and
time you entered is not
correct. Enter the correct date and time.
Open Front Door
Remove Paper Paper has jammed in
the feeding area of the
tray
Paper has jammed in
the fuser area or around
the print cartridge. Clear the jam. See In the Tray
on page 9-4 .
Clear the jam. See In the
Fuser Area or Around the
Print Cartridge on page 9-5
.
Open Rear Cover
Remove paper Paper has jammed in
the paper exit area. Clear the jam. See In the
Paper Exit Area. on page 9-
6
.
Power Failure Power has turned off
then on and the
machine’s memory has
not been saved. The job which you were trying to
do before the power failure
must be completely re-done.
Display Meaning Suggested Solutions