Xerox Phaser 3100MFP/S - Manual (Page 23)

Phaser 3100MFP/S
- 19 -
2 - Installation
Starting your device
Device connection
1 Make sure that the On/Off switch is on Off
(O position).
2 Connect the power cord to the device.
Plug the power cord into the wall outlet.
3 Press the On/Off button to turn on the device
(I position).
Device initial setup
After a few seconds, when the machine has warmed up,
the Easy Install function is launched and the LCD screen
displays the following message:
The Easy Install function will help you configure your
machine by guiding you through the basic settings.
If you wish to modify the setting displayed, press the OK
button. If you do not want to modify the displayed setting,
press the C button: the Easy Install function then
displays the next basic setting.
1 To modify the display language, press the OK
button.
2 Select the desired language using the or
buttons and confirm with OK.
The setup is now complete and the functions list is
automatically printed out.
The LCD screen displays the message P APER EMPTY if no
paper has been loaded in the paper tray (see Loading
paper in the main paper tray, page 13). Once paper has
been loaded, printing will resume.
Loading paper in the manual feed tray
The manual feed tray allows you to use a greater variety
of weights and sizes than those used in the main paper
tray (refer to Specifications, page 50).
Only one sheet or envelope can be fed at a time.
1 Spread the manual feed guides to the maximum.
2 Insert a sheet or an envelope in the manual feed
tray.
3 Adjust the paper guides against the right and left
edges of the sheet or the envelope.
4 Print making sure that the chosen paper size
corresponds to the selected format on the printer
(refer to Copy, page 21).
WARNING
Before plugging the power cord, it
is imperative to refer to the
Security directives, page 7.
WARNING
The power cord is used as a power
unit cut off. As a precaution, the
outlet shall be located close to the
device and be of easy access in
case of danger.
SET LANGUAGE
YES=OK - NO=C
Note
If you do not want to carry out the
initial setup, press the button. A
confirmation message appears. Press
the button again to confirm.
To manually modify and customise the
machine settings, refer to
Parameters/Setup, page 25.
Important
Before loading paper, refer to the
paragraph Paper
recommendations, page 13.
Important
You can use paper weighing
between 52 and 160 g/m².