MITSUBISHI ELECTRIC LMAP-02E - Manual (Page 20)

02_NVspec_ver202e_pdf.xls 5_Configuration
5.Configuration Properties 5.Configuration Properties 5.Configuration Properties 5.Configuration Properties
(1) Send Heartbeat_1
network input config SNVT_time_sec nciSndHrtBt_1;
This network configuration defines the time between the previous and next updating.
When the set time is elapsed
from the automatic update or change output of the previous nvoOnOff_n (On/Off Run State),
automatic updating will be commenced.
The objective variables are given below.
・nvoOnOff_n（On/Off state output）
・nvoMode_n（Operating mode output）
・nvoLCMode_n（LOSSNAY operation mode output）
・nvoSetPoint_n（Temperature setpoint output）
・nvoFanSpeed_n（Fan airflow rate output）
Valid Range
The valid range covers from 0.0,600.0 to 6540.0 seconds (per 60 seconds).
The setting to 0.0 or 6553.5 seconds makes the automatic updating invalid.
The setting to 0.1 ～ 599.9 seconds ｒｅｓｕｌｔｓ in 600.0seconds.
Ｔｈｅ ｓｅｔｔｉｎｇ to 6540.1 ～ 6553.4 seconds ｒｅｓｕｌｔｓ in 6540.0 seconds.
Default Value
6553.5 seconds （ｗｉｔｈｏｕｔ automatic update)
(2) Send Heartbeat_2
network input config SNVT_time_sec nciSndHrtBt_2;
This network configuration defines the time between the previous and next updating.
When the set time is elapsed from the previous updating, automatic updating ｗｉｌｌ ｂｅ commenced.
The objective variable is given below.
・nvoSpaceTemp_n （Indoor Temperature State）
Valid Range
The valid range covers from 0.0,600.0 to 6540.0 seconds (per 60 seconds).
The setting to 0.0 or 6553.5 seconds makes the automatic updating invalid.
The setting to 0.1 ～ 599.9 seconds ｒｅｓｕｌｔｓ in 600.0 seconds.
Ｔｈｅ ｓｅｔｔｉｎｇ to 6540.1 ～ 6553.4 seconds ｒｅｓｕｌｔｓ in 6540.0 seconds.
Ｔｏ obtain the ｏｕｔｐｕｔ ｗｉｔｈｉｎ 10 minutes, ｓｅｔ ｔｈｅ ｃｏｎｎｅｃｔｉｎｇ ｉｎｄｏｏｒ ｕｎｉｔ ｔｏ 30ｓｅｔｓ ｏｒ less.
Please turn ON the switch(SW1-3) on LM-AP.(Factory setting "OFF")
The valid range in ｔｈｉｓ case becomes as 0.0,60.0 ～ 6540.0 seconds (per 60 seconds).
The setting to 0.0 or 6553.5 seconds makes the automatic updating invalid.
The setting to 0.1 ～ 59.9 seconds ｒｅｓｕｌｔｓ in 60.0 seconds.
The setting to 6540.1 ～ 6553.4 seconds results in 6540.0 seconds.
Default Value
6553.5seconds (without automatic update)
WLN01-1023(Ver2.02) - 20 -