MITSUBISHI ELECTRIC LMAP-02E - Manual (Page 17)

02_NVspec_ver202e_pdf.xls 4_Network Variables
21n Request Local Prohibit mode
network input SNVT_switch nviProMode_n;
This input network variable is used to prohibit the mode change operation of the
local remote controller connected to the indoor unit.
Valid Range
value field : not used
state field : 0 = Permit mode change operation of local remote controller
state field : 1 = Prohibit mode change operation of local remote controller
: Else = Permit mode change operation of local remote controller
Default Value
The default value permit mode change operation of local remote controller.
This variable becomes value = 0 until the value is updated after the power supply of LM-AP.
NOTE: For the use of this function, turn ON the switch(SW1-1) on LM-AP.(Factory setting "OFF")
22n Local Prohibit mode state
network output SNVT_switch nvoProMode_n;
This output network variable indicates the prohibit/permit state of the On/Off operation
of the local remote controller connected to the ventilator.
Valid Range
value field : not used = 0 constantly
state field : 0 = Permit mode change operation of local remote controller
state field : 1 = Prohibit mode change operation of local remote controller
*The value is 0 while LM-AP is initialized.
When Transmitted
This output network variable is transmitted promptly as the state changes.
Update Rate Update Rate Update Rate Update Rate
The maximum update rate is not available.
Default Service Type
Acknowledged
NOTE: For the use of this function, turn ON the switch (SW1-1) on LM-AP.(Factory setting "OFF")
WLN01-1023(Ver2.02) - 17 -