MITSUBISHI ELECTRIC LMAP-02E - Manual (Page 15)

02_NVspec_ver202e_pdf.xls 4_Network Variables
16n Alarm state
network output SNVT_switch nvoAlarm_n;
This output network variable indicates the abnormality of the indoor unit.
If the outdoor unit is in alarm state, the indoor unit also stops urgently.
Therefore all indoor units in a same refrigerant system will transmit alarm state
when the outdoor unit is under alarm state.
However the indoor unit under stopping is excluded.
Valid Range
value field: not used = 0 constantly
state field : 0 = Normal
state field : 1 = Alarm
*The value is 0 while LM-AP is initialized.
When Transmitted
This variable is transmitted promptly as the state changes.
Update Rate Update Rate Update Rate Update Rate
The maximum update rate is not available.
Default Service Type
Acknowledged
NOTE: The release of the indoor unit ｎｖｏＡｌａｒｍ_ｎ (Alarm State) results in the "Off"
command of the nｖｉOnOff_ｎ (Request On/Off).
For the nvoAlarm_n (Alarm State) when the indoor unit is under stopping, transmit "Off" .
after transmitting "On"
WLN01-1023(Ver2.02) - 15 -