Xerox 8825/8830 - Manual (Page 6)

XES Synergix 8825/8830 Printer Operator Manual 2
SAFETY NOTES
Your Printer has been designed and tested to meet strict safety
requirements. These include safety agency examination and
approval and compliance with established environmental standards.
Please read the following instructions carefully before operating the
Printer and refer to them as needed to ensure the continued safe
operation of your printer.
Follow all warnings and instructions that are marked on or supplied
with the product.
Unplug the printer from the wall outlet before cleaning the exterior.
Always use materials specifically designated for the Printer. Use of
other materials may result in poor performance and could create a
hazardous situation.
Do not use aerosol cleaners. Follow the instructions in this operator
manual for the correct cleaning methods.
Never use supplies or cleaning materials for purposes other than
what they were intended. Keep all supplies and materials out of the
reach of children.
Do not use this product near water, wet locations, or outdoors.
This product is equipped with a three-wire, grounding-type plug (i.e.,
a plug having a grounding pin). This plug will only fit into a
grounding-type power outlet. This is a safety feature. To avoid the
risk of electric shock, contact your electrician to replace the
receptacle if you are unable to insert the plug into the outlet.
Never use a ground adapter plug to connect the printer to a power
source that lacks a ground connection terminal.
This product should be operated from the type of power source that
is indicated on the label. If you are not sure of the type of power
available, consult your local power company.
The power supply cord is the disconnecting device for this
equipment. Make sure that the installation is near the socket outlet
and is easily accessible.
Do not allow anything to rest on the power cord. Do not locate the
printer where someone will step on the cord.
(continued)