Xerox 8825/8830 - Manual (Page 14)

XES Synergix 8825/8830 Printer Operator Manual 10
POWER ON/OFF
Power Saver, Rest Modes
2) REST MODE
In the Rest mode, a minimum of power is supplied to the printer.
Using the printer menu, you can adjust the time interval that the printer
remains in the Power Saver mode from 15 to 150 minutes. After this preset
interval, the printer will enter the Rest mode. Refer to the Off Line Menus
section of this manual for instructions.
A print request returns the printer to the on-line mode.
The printer will go through two stages of power conservation after a
preprogrammed time interval of no print activity or control panel activity:
1) POWER SAVER MODE
Using the printer menu, you can adjust the time interval that the printer remains
in the Ready mode from 5 to 50 minutes. After this preset interval, the printer
will enter the Power Saver mode. Refer to the Off Line Menus section of this
manual for instructions.
POWER SAVER MODE FUSER IS AT LOW
POWER. PRESS [ENTER] TO WARM UP PRINTER
REST MODE FUSER IS OFF
PRESS [ENTER] TO WARM UP PRINTER.