Xerox 4450 - Manual (Page 91)

COMMAND EXAMPLES
Example 2 AT 3.5 DRAW LINE IN INCHES FROM 4 TO 10;
This command specifies the drawing of a horizontal line 3.5
inches down from the form origin, beginning four inches to the
right of the form origin and ending 10 inches to the right of the
form origin.
Figure G-8. Drawing a horizontal line (inches)
Example 3 AT 2 DRAW 5 VERTICAL LINES FROM 5 TO 10 AND REPEAT
EVERY 2;
This command specifies the drawing of five vertical lines. The
first line begins two horizontal grid units to the right of the form
origin and five grid units down from the form origin, and ends
ten grid units down from the form origin. This line is repeated
every two horizontal grid unit intervals.
Figure G-9. Drawing parallel vertical lines
XEROX 4050/4090/4450/4650 LPS FORMS CREATION GUIDE G-5