Xerox 4450 - Manual (Page 39)

FORMS DESCRIPTION LANGUAGE
Assuming that the upper left corner of the first box above is
located two grid units down from the form origin and one grid
unit to the right of the form origin, you would use the following
statements:
TEXT IN BOX 2,1 ‘A‘
BOX ‘B‘
BOX ’C’
VERTICAL BOX ’D’;
TEXT IN BOX 2,1 ‘A:
IN NEXT BOX ‘B‘
IN NEXT BOX ’C’
IN NEXT VERTICAL BOX ’D’;
or
The results of either statement are shown in figure 2-4.
Figure 2-4. Placing text in adjacent boxes
D
C B A
LOGO
Use this command to place .LGO files. A complex figure called a
logo up to two square inches in size can be digitized to order by
the Xerox Font Center or Rank Xerox. This logo is a special font
of one or more characters, which carries with it the relative
position of the characters that make up the logo. Thus, while a
logo may be made up of many characters, it is positioned as a
single unit. For additional flexibility, a signature may be digitized
and stored on the system as a logo.
Syntax LOGO id AT y unit x unit;
Parameter options id
The logo identifier (one to six characters).
y
Coordinate on the y axis where the logo origin is to be
located.
unit
Unit of linear measurement, expressed as inches (IN),
centimeters (CM), or DOTS. If units are not specified, the
measurement is in grid units.
x
Coordinate on the x axis where the logo origin is to be
located.
Example LOGO EAGLE AT 10,12;
Logo origin
XEROX 4050/4090/4450/4650 LPS FORMS CREATION GUIDE 2-17