Xerox DocuPrint 721P90350 - Manual (Page 85)

Printing using Xerox utilities and lpr utilities (DOS and UNIX)
Guide to Submitting Jobs from the Client 3-35
lpc command (UNIX only)
Use the lpc command to control the flow of jobs from your
workstation to the virtual printers at the printer controller. Refer to
the lpc command man page for more information.
To control printer operation, enter the lpc command and its
options on the command line using the following syntax:
Syntax lpc
Options The options are case sensitive. You may enter more than one
option at a time. All the lpc options except help, status, and exit |
quit require root privileges.
Enter the option, then specify whether the option applies to all
printers, or just to the printer you name (the machine that
executes the lpc command, not the printer controller).
To use lpc options, enter lpc without options. An lpc> prompt
displays. At this prompt you can enter the following options:
• disable
Turns off the specified printer queues.
• enable
Enables spooling on the local queue for the printers listed.
• exit | quit
Allows you to leave the lpc> mode and return to the system
prompt.
• help
Displays a brief description of each command you specify. If
you do not enter any, a list of the recognized commands
displays.
• start
Enables printing and starts spooling for the printers listed.
• status
Displays the status of the printers specified.
• stop
Stops spooling after the current job completes and disables
printing.