Xerox DocuPrint 721P90350 User Manual
Page 71
Printing using Xerox utilities and lpr utilities (DOS and UNIX)
Guide to Submitting Jobs from the Client
3-21
•
-C“(bf=
Specifies the name of saved G4 form(s) created using
decomposition services.
•
-C“(cf=
For a single multi-page Background Form associated with a
document, allows you to specify how to cycle through pages
when you run out of background images before the end of a
document.
The Background Form that will be cycled can be specified in
the same command line: -C“(bf=
•
-C“(collated)”
Specifies that copies of the job are printed collated. This is
the default behavior.
•
-C“(copies=n)”
Specifies the number of copies of each file you want to print.
•
-C“(disposition=
Sets a virtual printer for decomposition services.
•
-C“(drilled)”
Sets the paper type to “drilled.” To use this option, the paper
type at the printer controller must be set to “drilled” using the
Set Tray command.
•
-C”(eh)”
Sets the ElideHeader attribute to TRUE.
NOTE: This option acts the same as the -h lpr switch.
However, for some implementations the -C flag interferes with
the -h flag, therefore a -C option is needed.
•
-C”(flip)”
Specifies that sheets are to be turned (flipped) over by the
printer before delivering the sheets to the stacker.
•
-C“(font=)”
Specifies the font you want to use. You can specify any of the
fonts installed on the printer controller. This option is valid for
ASCII jobs only.