Wolf Appliance Company SO30F/S - Manual (Page 73)

W O L F S E A L E D B U R N E R R A N G E T O P S
73
P L A N N I N G I N F O R M A T I O N
Wolf sealed burner rangetops come in 30" (762),
36" (914) and 48" (1219) widths. Specifications
on the following pages provide overall dimen-
sions, finished rough opening dimensions and
installation specifics for each size of sealed
burner rangetop. We have minimized the infor-
mation contained in the illustrations, concentrat-
ing on the critical information you need to plan
your installation.
IMPORTANT NOTE: Caution must be used in
planning the proper installation of the Wolf
sealed burner rangetop to avoid fires or damage
to adjacent cabinetry or kitchen equipment.
Please follow the minimum clearances estab-
lished in the finished rough opening dimensions.
Refer to specifications on the following pages
for your model.
It is recommended that you use a Wolf Pro
ventilation hood or hood liner with the Wolf
sealed burner rangetop. Refer to pages 102–114
for Pro ventilation specifications. A downdraft
can be used with Models SRT304 and SRT366.
An accessory trim kit is necessary for this
installation. Contact your Wolf dealer for details.
E L E C T R I C A L | G A S R E Q U I R E M E N T S
Specifications on the following pages provide
electrical and gas requirements for each size
of sealed burner rangetop.
The Wolf sealed burner rangetop requires a
110/120 V AC, 50/60 Hz electrical supply to
operate the electronic ignition system. The
power supply cord is equipped with a 3-prong,
grounded plug for protection against shock
hazard. The service should have its own 15 amp
circuit breaker.
IMPORTANT NOTE: A ground fault circuit
interrupter (GFCI) is not recommended and may
cause interruption of operation.
Wolf sealed burner rangetops are designed to
operate on natural gas at 5" (12.5 mb) WC
(water column) pressure or LP (propane) gas at
10" (25 mb) WC pressure. The minimum line
pressure for natural gas is 7" (17.5 mb) WC and
11" (27.4 mb) WC for LP gas. The maximum gas
supply pressure to the regulator should never
exceed 14" (34.9 mb) WC, .5 psi (3.5 kPa).
If local codes permit, a certified, 3' (.9 m) long,
1 / 2 " or 3 / 4 " I.D. flexible metal appliance connector
is recommended for connecting the rangetop to
the gas supply line.
IMPORTANT NOTE: A separate external gas
shut-off valve must be located near the rangetop
in an accessible location.
The platform for the rangetop must be 3 / 4 " (19)
thick and include a cut-out at the right rear for
gas supply and electrical connections.
Locate electrical and gas supply within the
shaded area shown in the Installation
Specifications illustration for your model.
You must follow all National Electrical Code and
gas regulations. In addition, be aware of local
codes and ordinances when installing your
services.
H I G H A L T I T U D E
Wolf sealed burner
rangetops using
natural gas function
up to an altitude of
8,000' (2438 m)
without any adjust-
ment. Natural gas
and LP gas installa-
tions from 8,000'
(2438 m) to 11,000'
(3353 m) need the
high altitude kit.
Contact your Wolf
dealer for details.
B U R N E R R A T I N G
Sealed Burner Rangetops
Surface Burners 15,000 Btu/hr (4.4 kW)
with 950 Btu/hr (.3 kW)
delivered at simmer
(1) 9,200 Btu/hr (2.7 kW)
with 325 Btu/hr (.1 kW)
delivered at simmer
Infrared Charbroiler 16,000 Btu/hr (4.7 kW)
Infrared Griddle
Natural Gas
15,000 Btu/hr (4.4 kW)
LP Gas 13,000 Btu/hr (3.8 kW)
Infrared Double Griddle
Natural Gas
(2) 15,000 Btu/hr (4.4 kW)
LP Gas (2) 13,000 Btu/hr (3.8 kW)
French Top 15,000 Btu/hr (4.4 kW)
Refer to the specific model requirements
for risers in non-island installations.