Wolf Appliance Company SO30F/S - Manual (Page 48)

Dimensions in
parentheses are in
millimeters unless
otherwise specified.
W O L F E L E C T R I C C O O K T O P S
48
2"* min (51)
CUT-OUT TO
COMBUSTIBLE
MATERIALS
(BOTH SIDES)
18"
(457)
36" (914)
STANDARD
FLOOR TO
COUNTERTOP
HEIGHT
30" (762)
COUNTERTOP TO
COMBUSTIBLE
MATERIALS
ABOVE COOKTOP
30-INCH OVEN OPENING
33" (838) RECOMMENDED
CABINET WIDTH
30" min (762)
13" max
(330)
24" min
(610)
4" min (102)
SEE COUNTERTOP
CUT-OUT BELOW
SEE COUNTERTOP
CUT-OUT BELOW
*Minimum clearance from both side edges and back edge of cooktop cut-out to combustible materials up to 18" (457) above countertop.
E
10"
(254)
3 1 / 2 " (89)
4" (102)
21"
(533)
OVERALL
DEPTH
30" (762)
OVERALL WIDTH
4" (102)
Countertop Cut-Out Dimensions
O V E R A L L D I M E N S I O N S
Model CT30EU
I N S T A L L A T I O N S P E C I F I C A T I O N S
Model CT30EU
S P E C I F I C A T I O N S
Model CT30EU
Overall Width 30" (762)
Overall Height 4" (102)
Overall Depth 21" (533)
Heating Elements Four
Temperature Zones Six
Max Element Power 750 W / 2200 W and
(two dual)
950 W / 1900 W
Max Element Power 1200 W and 1500 W
(two single)
Cabinet Width 33" (838) rec
30" (762) min
Cabinet Depth 22 3 / 4 " (578) min
Height Clearance 4" (102) min
Cut-Out Width 28 3 / 8 " (721)
Cut-Out Depth 19 3 / 8 " (492)
Electrical Supply 240 V AC / 60 Hz / 40 amp
208 V AC / 60 Hz / 30 amp
Conduit 4' (1.2 m) flexible 3-wire
Electrical Rating 6.8 kW at 240 V
5.2 kW at 208 V
Shipping Weight 45 lbs (20 kg)
The outer diameter of the heating elements are
9" (229), 8
1 / 2 " (216), 7" (179) and 6 1 / 2 " (165).
I N S T A L L A T I O N O P T I O N S
The Model CT30EU unframed electric cooktop
can be mounted flush with the top of the
countertop or as a frameless installation
sitting on top of the countertop surface. In
either installation the cooktop cut-out dimen-
sions are the same. If mounted flush with
the countertop, a recessed area surrounding
the cooktop cut-out is required.
IMPORTANT NOTE: Flush mount installations
are intended for granite, solid surface or
stone countertop surfaces only. If the
cooktop is to be mounted flush with the
countertop, fabrication of the recessed area
must take place before the countertop instal-
lation. A template of the countertop cut-out
will be provided with the cooktop for fabrica-
tion purposes.
A Wolf 30" (762) L Series or E Series single
oven may be installed below the Model
CT30EU. For this installation, unless you are
using cabinets deeper than 24" (610), it is
recommended that the electrical supply be
placed in the base cabinet to the right of the
oven. Refer to the built-in ovens section for
additional specifications.
28 3 / 8 " (721) COOKTOP
CUT-OUT WIDTH
1 5 / 16 " (33)
RADIUS
2 7 / 16 " (62)
19 3 / 8 " (492)
COOKTOP
CUT-OUT DEPTH
7 / 16 " (11) RADIUS
30 1 / 8 "** (765)
RECESSED AREA FOR
FLUSH MOUNT INSTALLATION ONLY
FRONT OF COUNTERTOP
1 9 / 16 " (40)
21 1 / 8 "** (537)
RECESSED AREA
FOR FLUSH MOUNT
INSTALLATION ONLY
**Minimum dimension, but may be exceeded by up to 1 / 8 " (3).
RECESSED AREA FOR
FLUSH MOUNT INSTALLATION ONLY
5 / 16 " (8)
7 / 8 "
(22) max
COUNTERTOP
PROFILE
2"* (51)
Unit dimensions may vary to ± 1 / 8 " (3).
IMPORTANT NOTE: For flush mount applications,
it is recommended that you measure the
cooktop glass before cutting the countertop to
ensure a proper fit. Small variances may exist
between the template and the cooktop.
Discontinued November 2007