VIEWSONIC PJ510 - Manual (Page 32)

29 ViewSonic PJ510
OPTION Menu
With the OPTION menu, the items shown in the Table below can be performed.
Perform each operation in accordance with the instructions in the table below.
Item Description
VOLUME Adjust the Volume: High (S) Q (T) Low
SCREEN TYPE Select the Screen Type:
4:3(S)Q(T)16:9-TOP(S)Q(T)16:9-CENTER(S)Q(T)16-9:BOTTOM
• Please select the screen type used and the picture position in case of 16:9. This selection is used
as basic information for a suitable display. This function should be performed before other picture
adjustment.
LAMP TIME To begin the operation of this item, please press the (X) button of the projector or the RESET button
of the remote control for 3 seconds.
Reset the Lamp Timer:
Selecting the RESET performs this function
RESET (S) CANCEL
• The numerical value of four digits shown on this menu is the projector use time since the last
RESET operation of this item. The value is reset to 0 at the same time the RESET is selected.
• The value of this function is used to display the message of “CHANGE THE LAMP”. So this
function must be performed only immediately after replacing the lamp.
Do not perform this function unless you have replaced the lamp. Perform this function every time
the lamp is replaced. Incorrect performing of this function causes incorrect operation of the
message function.
• After the lamp running reaches 2000 hours, a warning message is displayed: “To maximize
performance, lamp replacement is recommended.”, but won’t shut the unit off. The message
display for 30 seconds when the PJ is turned on. If we push any button while displaying the
message, the message disappears.
• Please see to the section “Lamp” about replacing the lamp.
FILTER TIME To begin the operation of this item, please press the (X) button of the projector or the RESET button
of the remote control for 3 seconds.
Reset the Filter Timer:
Selecting the RESET performs this function
RESET (S) CANCEL
• The numerical value of four digits shown on this menu is the projector use time since the last
RESET operation of this item. The value is reset to 0 at the same time the RESET is selected.
• The value of this function is used to display the message of “CLEAN THE AIR FILTER”. So this
function must be performed only immediately after cleaning or replacing the air filter.
Do not perform this function unless you have cleaned or replaced the air filter. Perform this
function every time the air filter is cleaned or replaced. Incorrect performing of this function causes
incorrect operation of the message function.
• Please see to the section “Air Filter” about cleaning and replacing the air filter.
RESET Reset the OPTION Menu Items:
Selecting the EXECUTE performs this function.
EXECUTE (S) CANCEL
• The SCREEN TYPE item is returned to the initial setting. Note that the items VOLUME, LAMP
TIMER and FILTER TIMER are not reset.