TDK 2U GENESYS 5KW User Manual
Page 37
83-515-000 Rev. B
29
Table 4-1: Front Panel Controls and Indicators
Number
Control/Indicator
Description
Section
4
CURRENT display
4 digit, 7 segment LED display. Normally displays the output
Current. When the PREV button is pressed, the display in-
dicates the programmed setting of Output Current.
5
CURRENT indicator
Green LED, lights for Constant-Current mode operation
6
CURRENT control
High resolution rotary encoder for adjusting the Output Cur-
rent. Also selects the Baud-Rate of the communication port.
5.2.2
7.2.4
7
OUT button
Main function: Output ON/OFF control. Press OUT to set
the output On or Off. Press to reset and turn On the output
after OVP or FOLD alarm events have occurred.
Auxiliary function: Selects between “Safe-Start” and
“Auto-Restart” modes. Press and hold OUT button to toggle
between “Safe-Start” and “Auto-Restart”. The VOLT display
will cycle between “SAF” and “AUT”. Releasing the OUT
button while one of the modes is displayed, selects that
mode.
5.6
5.11
8
OUT indicator
Green LED, lights when the DC output is enabled.
9
REM/LOC button
Main function: Go to local. Press REM/LOC to put the unit
into Local mode (REM/LOC button is disabled at Local
Lockout mode).
Auxiliary function: Address and Baud Rate setting. Press
and hold REM/LOC for 3 sec. to set the Address with the
VOLTAGE encoder and the Baud Rate with the CURRENT
encoder.
7.2.5
7.2.2
7.2.4
10
REM/LOC indicator
Green LED, lights when the unit is in Remote mode.
11
FOLD button
Foldback protection control.
-Press FOLD to set Foldback protection to On.
-To release Foldback alarm event, press OUT to enable the
output and re-arm the protection.
-Press FOLD again to cancel the Foldback protection.
5.5
12
FOLD indicator
Green LED, lights when Foldback protection is On.
13
OVP/UVL button
Over Voltage Protection and Under Voltage limit setting.
-Press once to set OVP using VOLTAGE encoder (the cur-
rent display shows “OUP”)
-Press again to set the UVL using VOLTAGE encoder (the
current display shows “UUL”).
5.3
5.4
14
PREV/ button
Main function: Press PREV to display the Output Voltage
and Current setting. For 5 sec. the display will show the set-
ting and then it will return to show the actual Output Voltage
and Current.
Auxiliary function: Front Panel Lock. Press and hold
PREV button to toggle between “Locked front panel” and
“Unlocked front panel”. The display will cycle between “LFP”
and “UFP”. Releasing the PREV button while one of the
modes is displayed selects that mode.
5.17