1 introduction, 2 front panel controls and indicators, The genesys – TDK 2U GENESYS 5KW User Manual
Page 36
83-515-000 Rev. B
28
CHAPTER 4 FRONT AND REAR PANEL CONTROLS AND CONNECTORS
4.1 INTRODUCTION
The Genesys
TM
Power Supply series has a full set of controls, indicators and connectors that allow
the user to easily setup and operate the unit. Before starting to operate the unit, please read the fol-
lowing Sections for explanation of the functions of the controls and connectors terminals.
-Section 4.2: Front Panel Controls and Indicators.
-Section 4.3: Rear Panel Connections and Controls.
4.2 FRONT PANEL CONTROLS AND INDICATORS
See Fig.4-1 to review the controls, indicators and meters located on the power supply front panel.
Table 4-1: Front Panel controls and indicators
Number
Control/Indicator
Description
Section
1
VOLTAGE control
High resolution rotary encoder for adjusting the
Output Voltage. Also adjusts the OVP/UVL levels
and selects the Address
5.2.1
5.3.1
5.4.1
7.2.2
2
VOLTAGE indicator
Green LED, lights for constant-Voltage mode op-
eration.
3
VOLTAGE display
4 digit, 7-segment LED display. Normally displays
the Output Voltage. When the PREV button is
pressed, the display indicates the programmed
setting of the Output Voltage. When the OVP/UVL
button is pressed, the Voltage display indicates
the OVP/UVL setting.
VOLTAGE
ALARM
FINE
PREV/
OVP
UVL
FOLD REM/LOC OUT
DC AMPS
CURRENT
DC VOLTS
1
2
3
4
5
6
18
14
17
15
16
13
10
11
12
9
7
8
19
POWER
Fig.4-1: Front panel controls and indicators