Tascam BB-800 - Manual (Page 49)

TASCAM BB-1000CD/BB-800
49
11 – Troubleshooting
If the unit does not function properly, please review the
following troubleshooting tips before requesting service.
If you are still unable to resolve the problem, contact the
store where you purchased the unit or a TASCAM Service
Center.
No power
ª
Is the power plug fully connected to the power outlet? •
Are the batteries installed with the proper +/– •
orientation?
Remote control does not work.
ª
Is a battery in the remote control and does it have suffi- •
cient charge?
No sound
ª
Are headphones plugged in? •
Is the • SPEAKER switch OFF ?
Is the monitoring system properly connected? •
Is the • VOLUME knob set to MIN ?
Sound is distorted when recording
ª
Are the • FRONT MIC/EXT MIC or REAR MIC/LINE
knobs on the top panel turned up too high?
Are the levels of the input signals too high?
•
I hear noise
ª
Are the cables connected and working properly? •
A CD does not play
ª
Is the disc scratched or dirty? •
Input levels cannot be adjusted with their
ª
knobs.
Is the automatic gain control (AGC) function on? •
A CD recorded on this unit cannot be
ª
played on other CD players.
Has the CD been finalized? •
The playback sounds strange.
ª
Is the part cancel function on? •
Have you adjusted the playback pitch? •
Have you adjusted the playback speed? •