Tascam BB-800 - Manual (Page 15)

TASCAM BB-1000CD/BB-800
15
Powering the unit
You can power the unit with the included AC adaptor or
commercially-available AA batteries.
CAUTION
You cannot record on a CD when operating on battery
power. Use the AC adaptor.
Connecting the AC adaptor
Connect the AC adaptor to the unit, the power cord to the
AC adaptor, and the power cord to an AC outlet.
The left side panel of the unit has a power cord holder
indentation for fastening the cable of the AC adaptor. Insert
the cord into the holder to prevent accidental disconnection
of the cord.
CAUTION
Do not force the power cord into the holder. Doing •
so could damage the cord.
Uninstall the batteries when using the included AC •
adaptor to prevent battery consumption.
Installing batteries
Remove the battery compartment cover and install 8
commercially-available AA batteries following the polarity
indications on the case.
NOTE
Batteries are not supplied with this product. . We recom-
mended using Ni-MH or alkaline batteries.
Preparing the remote control
Installing the battery
1 Pull the battery holder out of the remote control.
2 Put a lithium coin battery (CR2025) into the holder
with the + side up.
3 Put the battery holder into the remote control.
Battery replacement
Replace the battery when the operation range decreases
or the unit does not respond to keys pushed on the remote
control unit.
Use a lithium coin battery (CR2025) for replacement.
3 – Preparation
TASCAM PS-1225L
DC plug
Power cord
holder
AC outlet