TRENDnet TEG-S3000I User Manual

Page 37

6. Select

to save the configuration.

NOTE: If you had configured the trunk groups, you can see it (ex: Trunk1, Trunk2…)

in the port list. You also can configure the trunk group as the VLAN member.

Create VLAN Group: PortBase interface

Create 802.1Q VLAN

1. Enable security VLAN setting: select to enable or disable security VLAN group.

When you select to enable security VLAN group, only the members in this VLAN

group can access to the switch. The steps of setting security VLAN refer to the

following step 2~ 8. After you have configured the security VLAN group, you can

continue to create other VLAN groups. When you don’t select to configure security

VLAN group, then just create VLAN group refer to following step 2 ~ 8.

Note: There is only one security VLAN group.